[A-DX] [studio1] ==> HAMLIB ==> [IC-R75]

[Roger]

Now I have found a way out from Studio 1 to directly control the IC-R75
For this purpose one can use the hamlib.
http://www.rhci-online.de/HamLib-IC-R75.gif

Here are the contents of ExtIO_HamLib.cfg:

========================================================================================
# write log messages to ExtIO_HamLib.log?  0 for no. 1 for yes.
1
# model number as used in "rigctl -m <model>"
# also see rigctl --list
339
# radio device as used in "rigctl -r <port>" - full line is used!
com1
# LO / IF frequency offset f.e. 12000
-11660
# set rigmode? 0 for no. 1 for yes
0
# rigmode if previous option is yes:
# you should try one of
#    RIG_MODE_NONE    =    0    -- None
#    RIG_MODE_USB    =    4    -- Upper Side Band
0
# Hamlib debug level
# you should try one of
#    RIG_DEBUG_NONE    =    0    -- None
#    RIG_DEBUG_ERR    =    2    -- Only serious errors
#    RIG_DEBUG_TRACE    =    5    -- Highest verbosity, including serial 
traces
0
# rig conf params as used in "rigctl -C <PARM=VAL>*" - empty line for none
# for example: stop_bits=1,serial_handshake=None
# also see "rigctl --show-conf -m <model>"
========================================================================================


"339"  is the model number for the ICOM R-75.
complete list for other devices here:
http://www.rhci-online.de/rigctl-l.gif


-11660 is my special offset for the IC-R75-IF-mixer (-11,66 kHz)


-In the imported eibi-csv  then I had (with a hexeditor) all 
"AM"-records replaced with "SAM"......
  ....S-AM in Studio1 is just a main feature .....


roger