Re: [A-DX] Einstellungen bei HDSDR und Perseus

[Roger <roger.roger@xxxxxx>]

Am 18.03.2012 16:36, schrieb Andreas Hatting:
> AGC Threshold
================================================

http://www.w3fpr.com/K3_AGC.htm

AGC THR

The AGC Threshold setting determines how weak the "signal" can be that 
begins to activate the AGC.  It can be set so low that even the band 
noise will activate the AGC.  Look at your S-meter while there are no 
signals on the band.  If the S-meter is indicating anything at all, then 
the AGC is being activated by the band noise.  If the indication is only 
S-1 and perhaps an occasional blink of the S-2 bar, that is usually a 
tolerable situation, but if you have an S-5 noise level at your location 
with your particular antenna and on a particular band, you will want to 
change the AGC Threshold.

A higher AGC THR setting will raise the level where the K3 AGC response 
begins, so try higher settings to see what the effect is for your situation.

===================================================


ist zwar nicht aus der Hilfe von HDSDR, sollte aber überall zutreffen.......


roger
--
-----------------------------------------------------------------------
Diese Mail wurde ueber die A-DX Mailing-Liste gesendet.
Admin: Christoph Ratzer, OE2CRM  http://www.ratzer.at
-----------------------------------------------------------------------
Private Verwendung der A-DX Meldungen fuer Hobbyzwecke ist gestattet, jede
kommerzielle Verwendung bedarf der Zustimmung des A-DX Listenbetreibers.